How to add Sovol SV06 to the original Cura

*This method is available on the version of Cura V5.1.1 and above, the old version of Cura may cause import failure. If you would like to use the SV06 with the original Cura, please follow the two methods listed below. SV06 Cura Slicer: DOWNLOAD here 一、Method A:Modify dimensions and parameters directly on the SV01 model in Cura, and import the ...
Continue reading

How to level the bed on Sovol SV04 IDEX 3D Printer

SV04 Bed Leveling Guide 1. Inspect the right extruder at first. Loose the 4 screws on both sides with H1.5 Allen screwdriver (Just loose, don't unscrew completely. If you do not know what is the appropriate condition you can tighten it first, and then loosen it for 1~2 turns to make sure the right side extruder can be adjustable up and down fre...
Continue reading