How to Flash touch Screen firmware for Sovol SV01

1.New SD card must to be format to the one that can be recognized by the screen.


Start=>> running=>> Input command to enter DOS system(win7 system, please input cmd), input format/q g:/fs:fat32/a:4096.

G is the disk number of your SD card. Please noted that right click to format is invalid; SD card capacity must within 2-16G.

2.Then Put the File I send into the SD card, plug the SD card into the touch screen.


3.Turn on the printer, and it will flash by itself.

4.Power off , remove the SD card and restart.

Then please  flash the firmware for the mainboard, connect the printer and computer with usb cable, find out "Update firmware" in Cura software,

Firmware download: https://sovol3d.com/pages/download 

3 Kommentare

John Marshall

OK So my question here is what firmware do i use with the Version 2 silent board to go with the touch screen is it the same one listed or is it different?

John Marshall
John Marshall

Ok i just got my new touch screen and there was no mem card with the firmware in the box. also i upgraded my main board recently to the new Ver.2 silent board what are the instructions for this install.

John Marshall
Alex Weiss

I got the new touchscreen today. But where do I get the Firmware for the touchscreen? There was no card in the package…And on your Download page I didn’t find any file for this…. Greetings Alex

Alex Weiss

Hinterlasse einen Kommentar